Rajan Arora
CCNA Routing and Switching
74 Answers
Difference between cumulative distance and feasible distance?
author
,
CCNA Routing and Switching
Comulative Distance : Total distance from a source  to a destination network/prefix. Feasible Distance : Best ( MInimum ) Distance from source to a particular destiantion network/prefix [ In case mu...
I want to go in it sector but i am little bit whether i go for mca or ccie (in security) for the better job?
author
,
CCNA Routing and Switching
Buddy MCA is just one more degree after BCA again you have to go with cramming of some subjects. But CCIE security is a course which can provide you live network experience with a better job.
How much sallery in ccna r&s courses?
author
,
CCNA Routing and Switching
Salary depends upon technical skills as well as communication skills. As a CCNA freshers salary 15k to 20k.
How can I make communication between Vlan 100 to vlan 50 ?
author
,
CCNA Routing and Switching
On R0 make a sub interface of vlan 100 on interface fast 0/0  and on another router R1 make subinterface of vlan 50 of interface fast 0/0. then do static routing between R0 and R1  R0(config)#ip ...
How many broadcast domain and collision domains are there in the diagram below ?
author
,
CCNA Routing and Switching
2 Broadcast Domain and 5 Collision Domain : Broadcast Domain  : As R1 has two ports so 2 broadcast domains because router has per-port broadcast domain. Collision Domain : As routers and switches h...
Subnetting on 255.255.255.128 /25 network address: 172.16.0.0?
author
,
CCNA Routing and Switching
Network 172.16.0.0 Subnet Mask : /25 = 255.255.255.128 (   by default its 255.255.0.0 means change has been done in 1st and 2nd octet )                                         ...
Directly connected N/W isn't showing up in the route table?
author
,
CCNA Routing and Switching
Line protocol of serial links is down that is the main reason why directly connected networks is not shown in routing table [ because routing table will only show route if line protocol of that specif...
What are basic commands of EIGRP?
author
,
CCNA Routing and Switching
EIGRP Practical :  To verify Interfaces on which eigrp is enabled :  show ip eigrp interfaces To verify neighborship :  show ip eigrp neighbors To verify protocol running : show ip protocol...
What is difference between Static Routing and Default Routing?
author
,
CCNA Routing and Switching
Static Routing : --Most Preffered Route. --Route for a specific network.   Default Routing : --Least Preffered Route. -- It signifies all network's. -- Also known as static default because...
IS EIGRP open standard or Cisco Proprietary protocol?
author
,
CCNA Routing and Switching
Initially EIGRP is Cisco Proprietary protcol but back in 2013 cisco made EIGRP as a open standard protocol which can work on all company devices.