lets say there are 2 routers and both the loopback are reachable with the IGP protocol and the BGP is configured on loopbacks
Neighbor 2.2.2.2 remote-as 100
Neighbor 2.2.2.2 remote-as 100
do i need to run update-source loopback command on both the routers or just one router
i have configured the same topology but bgp is up and the networks are advertised by only enabling the bgp update-source loopback 1 only one one router.
Can someone please help on this
- Total 1 Answer
- 1148
Hii,
According to the BGP , if you are configuring indirect neighborship than update source command must be configured. As per your configuration , it is working fine. Because when you update source on one router that router will generate by using its own loopback as source 1.1.1.1 and destination will be the neighbor loopbacka address. when the neighbor router will recieve BGP message that router will give reply back to 1.1.1.1 , because of this it is working in BGP.
hope it helps..
- How can you guarantee a job for students who has no experience in Networking field?
- How to configure VPN between Cisco Router and ASA Firewall?
- How to configure RIPV2 with no auto summary?
- How to configure PAT (Port Address Translation)?
- How to configure Default Routing on Cisco Routers?
- What is the scope of CCNA course in India?
- What is scope of CCIE?
- How to remember 7 layers of OSI Model?
- How much salary can we get after doing CCNA course in Delhi Gurgaon?
- How many CCIE’s are there worldwide?
- Is it possible to pass CCIE Certification in 1st attempt?